Projects


prototypeSPI Flash Programmer V2

This programmer supports: ST Micro M25(E), ST Micro M45(E), Macronix MX25L, Atmel AT25FS, Atmel AT25DF, Atmel AT25F, Amic A25LxxP, Amic A25Lxxx, Eon EN25(B/D/F/P) read only, Winbond W25X, Winbond W25Q (OTP), SST SST25(LV/VF)xx, SST SST25VFxxxB, Spansion S25FL and ESMT F25L.

Get your  assembled SPI Flash Programmer v2 for 25€ .


USB_IR_TESTER1USB IR Tester

This is a great, simple project and you can connect this IR Tester on a usb. It can be used  to “see” or to check if your remote control is still working.

Get your  assembled USB IR Tester for 7€.


3V3PRODUCT13.3V Reg Board

The 3.3V REG  board is used to reduce the power supply voltage. The additonal board should be provided with a 5V DC voltage via a screw terminal CN1.

Get your  assembled 3.3V Reg Board for 6€.


20141115_144538AUDIO AMP BOARD – LM386

The LM386 is a power amplifier designed for use in low voltage consumer applications. The gain is internally set to 20 to keep external part count low, but the addition of an external resistor and capacitor between pins 1 and 8 will increase the gain to any value from 20 to 200.


PICAPIC18F2550 BOARD

The PIC18F2550 is a really popular USB chip from Microchip. This Board is miniature development system that enables you to experiment with the PIC18F2550
microcontroller.


TDA7052AAUDIO AMP BOARD TDA7052

This is a very  simple Circuit Diagram for Amplifier of 1,2W mono audio output. The amplifier is based on a single IC TDA7052. It is in 8-pin DIL (Dual-In-Line) package. The IC TDA7052 is specially designed for battery-operated audio circuit for amplifier like tape recorders, radios etc.


5V-3V3 REG BOARD 3D15V – 3.3V REG BOARD

The board includes AMS1117 – 5V voltage regulator and AMS1117–3.3V, Voltage Regulator, providing fixed supply voltages. It features three voltage input options: a screw terminal connector, DC adapter connector and USB connector. It can operate on 6-12V DC power supply and has separate screw terminals for 3.3V and 5V outputs.


eagleUp_Breadboard Power Supply_board_top  Breadboard Power Supply

The Breadboard Power Supply includes AMS1117 – 5V voltage regulator and AMS1117–3.3V voltage Regulator, providing fixed supply voltages. It features three voltage input options: a screw terminal connector, DC adapter connector and USB connector.


eagleUp_TQFP44_board_top  TQFP44 Breakout Board to Dip

This is a 44 pin TQFP to DIP breakout board. Ideal for ATmega32 and other chips with standard 0.8mm pin spacing 44-pin TQFP package.


5SO8 Breakout Board to Dip

This SO8 Breakout Board is designed with Eagle Cadsoft Software. Dimension of the board is 14.21 x 10.59mm.